17
ENGLISH
06.3 COMPONENTS
The fireplace is supplied with a JOLLY ME-07-F burner and preassembled and tested pellet hopper, in wooden crate on pallets, packed
with a cellophane hood, polystyrene and with the following parts:
•
Assembly, use and maintenance manual
•
Standard pellet hopper with capacity of approx. 41 kg
•
JOLLY MEC pellet burner
•
Control panel with electronic controller
•
Cast-iron grille for wood burning (1)
•
Hot air vents (2)
•
Wrench for burn pot locking screw (3)
•
Hot air and comburent air aluminium pipe (4)
•
Humidifier and spray kit (5)
•
Cleaning and use tools (see chapter 08.4)
•
Fan (410 m
3
/h) (6)
When refitting, make sure the electrical element is correctly inserted in the support fixed to the burn pot container
(when fixing with the screws, the flange must protrude approx. 2 mm with respect to the face of the assembly plate).
NOTE
• Pellet hopper components
The JOLLY MEC burner and pellet hopper can be removed for transport.
1. Disconnect the power supply then detach the connectors.
2. Loosen the hopper/burner connection clamp.
3. Undo the two M8 screws inside the pellet hopper and remove the
hopper.
4. Loosen the M6 locking screw on the burn pot container and remove
the burn pot.
5. Remove the ash pan.
6. Undo the M6 screws securing the burner to the boiler and remove
the burner.
7.
Proceed in reverse order to refit.
To replace the electrical element
1. Disconnect the power supply then detach the connectors.
2. Undo the M6 screw and remove the protection casing.
3. Undo the three electrical element support M4 screws and remove
the electrical element.
4.
Proceed in reverse order to refit.
A.
Standard pellet hopper
B.
Level sensor (simplified electronic controller)
C.
Hopper/burner connection clamp
A
B
C
C
1
4
5
6
3
2
