3.5 Ink cartridge maintenance
1. If the ink cartridge is planning not use for a long time, it is recommended to remove the ink cartridge from the
printer and place
it in a clean sealed bag or box to avoid contamination.
2. To keep good print quality, it is recommended to wipe the ink cartridge gently with a paper towel (either wet
or dry) before the ink cartridge is inserted back to ink cartridge stabilizer or print results are unclear.
3. If the print out appear multiple white lines or prints blur, please refer to section 3.4.5 to conduct print test and
3.5.2 to wipe ink cartridge.
Figure 3.5.1 Ink cartridge maintenance
3.6 Placement and orientation
3.6.1 Orientation of Mug cake、or test platform
1. Place the mug
、
cake
、
test platform at the center
of the coaster
2. Please be noted, the dimensions at print area are restricted at 10cm in diameter and 7cm ~ 17cm in height.
3. If your are using mug, please put the handle along the coaster in the direction of the convex red dot.
Figure 3.6.1 Placement and orientation
3.6.2 Milk foam, cream or foam preparation
Please refer to the illustration below to ensure the height
of the milk foam, cream or foam is related to the mug.
An example is printed on the Coffee Latte:
1. When preparing the Coffee Latte, the height of the milk foam must be as high as the cup
2. If the milk foam is too high (as shown in the left figure below), the milk foam will contaminate the ink cartridge and
clog ink cartridge.
3. Conversely, if the milk foam is too low (such as "lower right), so that the printed image will be blurred
· 09 ·
①
②
③
④
