Johnson J2R4SUC 2007, Руководство по обслуживанию

Страница: 53 / 179

51
MAINTENANCE
PRE-SEASON SERVICE
3
PRE-SEASON SERVICE
If the outboard was removed from the boat for
storage, make certain it has been reinstalled with
factory specified hardware.
Crankcase Oil
•
Check oil level
•
Add oil as needed
Gearcase Lubricant
•
Check the lubricant level.
•
Inspect gearcase for leaks. If leak is apparent,
pressure and vacuum test gearcase.
•
Repair gearcase as needed.
Operational Checks
•
Steering
•
Throttle and shift
•
All other accessories
Fuel System
•
Inspect entire fuel system for leaks prior to start-
ing outboard. Repair all leaks.
•
Start outboard and reinspect.
SUBMERGED ENGINES
Once an outboard has been submerged in fresh
or salt water, it must be serviced within three (3)
hours of recovery. Immediate service can mini-
mize the corrosive affect that air has on the pol-
ished surfaces of the crankshaft, connecting rods,
and internal powerhead bearings.
IMPORTANT:
If outboard cannot be started or
serviced immediately, it should be resubmerged in
fresh water to avoid exposure to the atmosphere.
Engine Dropped Overboard
(Not Running)
Disconnect battery cables at the battery.
Rinse powerhead with clean water.
Remove spark plug leads and spark plugs.
Place outboard in horizontal position (cylinder
heads down). Slowly rotate flywheel in a clock-
wise rotation to work all water out of powerhead.
IMPORTANT:
If sand or silt may have entered
the outboard, DO NOT attempt to start the it. Dis-
assemble and clean.
Place engine in upright position. Drain, disassem-
ble, and clean carburetor.
Disassemble all electrical connectors. Clean con-
nectors and terminals, and treat with water dis-
placing electrical spray. Apply
Electrical Grease to
terminals prior to reassembly. Coat all exposed
solenoid terminals and engine grounds with
Black
Neoprene Dip.
Clean and inspect all electrical components.
Replace damaged or corroded components prior
to returning the outboard to service. Electric start-
ers should be disassembled, cleaned, flushed
with clean water, and treated with water displacing
electrical spray prior to reassembly.
Change oil and filter.
Remove carburetor for draining, disassembly and
cleaning.
WARNING
Failure to check for fuel leakage could
allow a leak to go undetected, resulting in
fire or explosion.