Johnson Outdoors Scubapro S-TEK, Руководство пользователя

Страница: 20 / 40

20
5.2 S-TEK PRO Harness (Stainless or Aluminium) Setup
5.2.1 Shoulder Strap and D-Ring Location
While standing, don your harness. Lift your
elbows ensuring your arms are parallel
to the ground and point your thumb
toward the shoulder strap (fig.5) to get an
indication of the correct D-ring placement.
Adjustment of the Shoulder Strap length,
as well as the chest D-ring location, is
set using the excess webbing at the top
section of your S-TEK PRO Harness on
the back of the back plate (fig.5-1). We
recommend using this method for D-ring
shifting (rather than feeding the webbing
through the Monprene® Shoulder pads
and Tri-Glide/D-ring unit) in order to ensure
the TEK-LOC adjustment buckles on the
Shoulder Straps are in the correct position.
You should allow approximately 20cm
of excess webbing to ensure you can
re-adjust your harness depending on
thickness of exposure protection or
configuration changes.
Adjust the Shoulder Strap length or chest
D-ring placement by feeding the webbing
through the Tri-Glide (fig.5-2) so that, once
your harness is donned and the TEK-LOC
buckles are tightened, your D-rings are
in the correct location. Shoulder Straps
should be adjusted to allow good freedom
of movement without overly restricting your
harness and breathing.
Ensure you do not have more than 15-20cm
of excess webbing from the TEK-LOC
adjustable buckles (fig.5-3). Too much
webbing could increase drag and irritation!
fig. 5-1
fig. 5
fig. 5-2
fig. 5-3