Johnson Controls YVAHP072B31S, Руководство по обслуживанию

Страница: 497 / 1796

Service Manual
1-481
INSTALLATION
4. Select the indoor unit for “Main Unit Register”.
Ɣ Touch “<” or “>” on the upper right area
of the touchscreen and the indoor units
display is changed.
Ɣ The information of the refrigerant cycle
numb and indoor unit address are indicated
in the indoor unit button as “Refrigerant
Cycle No. - Indoor Unit Address”.
Ɣ Select the indoor unit button by touch. The
selected button is trimmed with an orange
outline. If the selected button is touched
again, the indoor unit selection is canceled.
Ɣ The indoor unit that is already registered as
the main unit cannot be selected.
(The button color is blue.)
< About the Indoor Unit Selecting>
Ɣ The indoor unit which letters are
highlighted in red cannot be registered as
the main unit. In this case, the indoor unit
is registered as the sub unit automatically.
Ɣ When the indoor unit with a fan speed of
Four, and fan speed setting Three becomes
intermixed in the same Remote Control
group, register the indoor unit with a fan
speed of Four as a Main Unit.
Ɣ When the indoor units such as “with auto
louver function” and “without auto louver
function” are mix-installed in the same
H-LINK, register the indoor unit “with auto
louver function” on the priority basis as the
main unit. If the unit “without auto louver
function” is registered as the main unit, the
auto louver function cannot be used in this
H-LINK. (The same applies to the other
functions.)
5. Touch “Register” to register the main unit
while the group and indoor unit are selected.
Ɣ If the group and indoor unit for the main unit
are not selected, “Register” will be displayed
in gray but cannot be selected.
Ɣ The button color of the registered group
and indoor unit are changed to blue and the
information is displayed in the button group
shown below.
< Group Button >
<Indoor Unit Button >
Proceed to the main unit register, depending
on the setting.
Ɣ Continue “Main Unit Register” ...(3)
Ɣ Exit “Main Unit Register”. ..........(6)
6. Touch “Setting Complete” to register the
group and return to the Group Register
menu screen.
7. Touch “Monitor screen” to return to Monitor screen.
8. Touch “Service Menu” to return to Service
Menu screen.
Block No. Group No.
I.U. Address
Main Unit
Ref. Cycle No.
1-1
00-00
Ref. Cycle No.
Group No. Block No.
I.U. Address
00-00
1-1
8
5
4
6
7