Johnson Controls YORK Tempo YLAA Series, Установка, эксплуатация и обслуживание

Страница: 151 / 192

FORM 150.72-NM1 (1020)
151
JOHNSON CONTROLS
7
Option 12 – Power Fail Restart
Chiller auto restarts after a power failure.
After a power failure, the UNIT switch must be toggled
before restart at the unit is allowed. NORMALLY
MANUAL RESTART should NOT BE SELECTED.
Option 13 – Soft Start Enable/Disable
SOFT START “DISABLED” MUST be selected on all
chillers.
This message may not be viewable on non-European
chillers.
Option 14 – Unit Type
The UNIT TYPE message cannot be modified under
the UNIT keys.
“LIQUID CHILLER” must be dis -
played, or damage to compressors or
other components will occur if oper -
ated in the HEAT PUMP or CON -
DENSING UNIT modes.
If unit type needs to be changed to make the unit a liquid
chiller, remove power and then remove the jumper
between J11-7 and J11-12 on the I/O Board. Reapply
power to the micropanel and the microprocessor will
store the change.
Option 15 – Refrigerant Type
Refrigerant type R-410A must be selected under Service
Mode. Refrigerant type is displayed under the OPTIONS
Key, but is only programmable in Service Mode.
P O W E R F A I L R E S T A R T
A U T O
M A T I C
P O W E R F A I L R E S T A R T
M
A N U A L
S O F T S T A R T
D I S A B L E D
U N I T T Y P E
L I Q U I D C H I L L E R
R E F R I G E R A N T T Y P E
R – 4 1 0 A
Do not select this option on R-410A chillers.
Option 10 – Manual Override Mode
This option allows overriding of the daily schedule
that is programmed. MANUAL OVERRIDE MODE
– DISABLED indicates that override mode has no
effect.
or
Manual Override Mode is enabled. This is a service
function and when enabled, will allow the unit to
start when shut down on the daily schedule. It will
automatically be disabled after 30 minutes.
Option 11 – Current Feedback Options
Installed
This mode should be selected when the panel is not
equipped with current sensing capability.
or
This mode should be selected when an optional
2ACE Module is installed to allow combined current
monitoring of all systems by sensing current on the
incoming line.
or
This mode should be selected when an optional
2ACE module is installed to allow individual current
monitoring of each system. SYS 1 input is to J7 of the
I/O. SYS 2 input is to J8 of the I/O.
F A N C O N T R O L
A M B I E N T & D S C H P R E S S
M A N U A L O V E R R I D E M O D E
E N A B L E D
C U R R E N T F E E D B A C K
N O N E
C U R R E N T F E E D B A C K
O N E P E R U N I T
C U R R E N T F E E D B A C K
O N E P E R S Y S T E M
M A N U A L O V E R R I D E M O D E
D I S A B L E D