TEC2102-3 N2 Networked Heat Pump Thermostat Installation Instructions
1
Applications
The TEC2102-3 Thermostat is an N2 networked device
that provides control of heat pump equipment. The
technologically advanced TEC2102-3 Thermostat
features a Building Automation System (BAS) N2 Bus
communication capability that enables remote
monitoring and programmability for efficient space
temperature control.
North American Emissions Compliance
United States
Canada
Installation
Location Considerations
Locate the TEC2102-3 Thermostat:
•
on a partitioning wall, approximately 5 ft (1.5 m)
above the floor in a location of average
temperature
•
away from direct sunlight, radiant heat, outside
walls, behind doors, air discharge grills, stairwells,
or outside doors
•
away from steam or water pipes, warm air stacks,
unconditioned areas (not heated or cooled), or
sources of electrical interference
Note:
Allow for vertical air circulation to the
TEC2102-3 Thermostat.
IMPORTANT:
The TEC2102-3 Thermostat is
intended to provide an input to equipment under
normal operating conditions. Where failure or
malfunction of the thermostat could lead to personal
injury or property damage to the controlled
equipment or other property, additional precautions
must be designed into the control system.
Incorporate and maintain other devices such as
supervisory or alarm systems or safety or limit
controls intended to warn of, or protect against,
failure or malfunction of the thermostat.
This equipment has been tested and found to
comply with the limits for a Class A digital device
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference when this equipment is
operated in a commercial environment. This
equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instruction manual, may cause
harmful interference to radio communications.
Operation of this equipment in a residential area is
likely to cause harmful interference, in which case
the user will be required to correct the interference
at his/her own expense.
This Class (A) digital apparatus meets all the
requirements of the Canadian Interference-Causing
Equipment Regulations.
Cet appareil numérique de la Classe (A) respecte
toutes les exigences du Règlement sur le matériel
brouilleur du Canada.
TEC2102-3 N2 Networked Heat Pump Thermostat
Installation Instructions
Part No. 24-9890-439, Rev. D
Issued July 14, 2009
Supersedes August 15, 2008
