Johnson Controls RW Series, Установка, эксплуатация и обслуживание, Страница: 13 / 40

13
RW SERIES REVERSIBLE CHILLER INSTALLATION MANUAL
1.6. Insulation
A. Heat pumps are built with factory installed insulation on any
surface that may be subject to temperatures below the room
dew point.
1.7. Brine Applications
A. Applications where the leaving fl uid temperature goes below
40°F a suitable brine solution must be used. Failure to do
so can cause immediate damage to the system. The brine
must be approved for use with heat exchangers. Automotive
antifreeze solutions are not suitable for use in brazed plate
heat exchangers.
B. The freeze detection must be adjusted appropriately for
brine applications. The brine solution concentration should
be at least 15°F below the lowest leaving fl uid temperature.
Water Quality Guidelines
RW Series Application Data cont.
Surface Condensation Chart
Room Ambient Condition
Surface Temperature
50°F 35°F 0°F
Normal (Max 85°F, 70% RH) 1/2" 3/4" 1"
Mild (Max 80°F, 50% RH) 1/8" 1/4" 1/2"
Severe (Max 90°F, 80% RH) 3/4" 1" 2"
Material 316 Stainless Steel
pH Acidity/Alkalinity 7 - 9
Scaling
Calcium and
Magnesium Carbonate
(Total Hardness)
less than 350 ppm
Corrosion
Hydrogen Sulfide Less than 1 ppm
Sulfates Less than 200 ppm
Chlorine Less than 0.5 ppm
Chlorides Less than 300 ppm
Carbon Dioxide 10 - 50 ppm
Ammonia Less than 20 ppm
Ammonia Chloride Less than 0.5 ppm
Ammonia Nitrate Less than 0.5 ppm
Ammonia Hydroxide Less than 0.5 ppm
Ammonia Sulfate Less than 0.5 ppm
Total Dissolved Solids (TDS) 1000 - 1500 ppm
LSI Index +0.5 to -0.5
Iron Fouling
(Biological Growth)
Iron, FE
2
+ (Ferrous)
Bacterial Iron Potential
< 0.2 ppm
Iron Oxide
Less than 1 ppm, above this
level deposition will occur
Erosion
Suspended Solids
Less than 10 ppm and filtered
for max. of 600 micron size
Threshold Velocity
(Fresh Water)
< 6 ft/sec
NOTES: Grains = ppm divided by 17
mg/L is equivalent to ppm
2/22/12