D-308439 MP-802 PG+ Rev.0
Installing the pet mask
Install the pet mask if you require pet immunity. The optimal installation height for pet immunity is
2.1
m (7 ft.). Pet immunity is for pets weighing up to 38 kg (85 lb).
Note:
Pet immunity is not supported at heights of 2.4 m (7.87 ft.) and above. Do not install the
pet mask if you are mounting the device at this height or above.
1.
To open the device cover, use a screwdriver to loosen the cover screw located on the
underside of the device. See A1 in the following figure. Press the snap to separate the base
from the cover. See A2 in the following figure.
Figure 3: Device cover removal
2.
Insert the tabs at the base of the pet mask into the bottom holes and align the tabs on the
sides with the holes on both sides. See the following figure.
3.
Press down gently to install the pet mask.
Figure 4: Installing the Pet Mask
4.
To close the device cover, clip the cover onto the device base and tighten the cover screw. See
the following figure.
MP-802 PG+ Wireless PIR Motion Detector Installation Guide
7
