D-308439 MP-802 PG+ Rev.0
Enrolling the device
1.
Refer to the control panel installation manual for the complete set of enrollment instructions
and testing procedures.
2.
From the
Installation
menu, enter the
Device enrollment
menu and select the option to add
a new device.
3.
Remove the battery pull-tab to power on the device and begin the auto-enrollment process.
If the battery pull-tab is not available or if the device does not automatically enroll, open the
device cover to trigger the enrollment. Alternatively, press the enroll button until the yellow
LED light turns on. See Figure 1 C.
4.
If requested, enter the PIN code printed on the device label.
5.
To manually enroll the device:
a.
Scan the QR Code on the device box, using the IQ4 camera if available, or see step b.
b.
Manually enter the device ID, printed on the product label, in the format ID:125-xxxx.
Note:
If the device has been powered up for more than 2 hours it will be identified by
the system only after the device has been reset.
The MP-802 PG+ is enrolled with device ID 125-XXXX. In fall back mode it enrolls as MP-802
K9-85 PG2 with device ID 126-XXXX.
6.
Select the desired zone.
7.
Configure any device parameters that are required.
8.
Mount and test the device. See
for information on testing the device.
MP-802 PG+ Wireless PIR Motion Detector Installation Guide
3
