676292-YIM-A-0111
YCCS TEC2603-4 BACnet® MS/TP Networked Multi-Stage Thermostat Controllers Installation Instructions
1
Applications
The TEC2603-4 Thermostat Controller is a BACnet®
Master-Slave/Token-Passing (MS/TP) networked
device that provides control of multi-stage heating/
cooling equipment in York Commercial Comfort System
(YCCS) applications.
The TEC2603-4 Thermostat Controller features an
intuitive User Interface (UI) with backlit display that
makes setup quick and easy. The thermostat controller
also employs a unique, Proportional-Integral (PI)
time-proportioning algorithm that virtually eliminates
temperature offset associated with traditional,
differential-based thermostat controllers.
North American Emissions Compliance
United States
Canada
Mounting
Location Considerations
Locate the TEC2603-4 Thermostat Controller:
•
on a partitioning wall, approximately 5 ft (1.5 m)
above the floor in a location of average
temperature
•
away from direct sunlight, radiant heat, outside
walls, outside doors, air discharge grills, or
stairwells, and from behind doors
•
away from steam or water pipes, warm air stacks,
unconditioned areas (not heated or cooled), or
sources of electrical interference
Note:
Allow for vertical air circulation to the
TEC2603-4 Thermostat Controller.
Installation
To install the thermostat controller:
1.
Use a Phillips-head screwdriver to remove the
security screw if it is installed on the bottom of the
thermostat controller cover.
Note:
Normally, the security screw is packaged
separately in a plastic bag with the thermostat
controller. Skip this step if the screw is not installed
on the bottom of the cover.
2.
Pull the bottom edge of the thermostat controller
cover and open the thermostat controller as
illustrated in Figure 1.
IMPORTANT:
The TEC2603-4 Thermostat
Controller is intended to provide an input to
equipment under normal operating conditions.
Where failure or malfunction of the thermostat
controller could lead to personal injury or property
damage to the controlled equipment or other
property, additional precautions must be designed
into the control system. Incorporate and maintain
other devices, such as supervisory or alarm systems
or safety or limit controls, intended to warn of or
protect against failure or malfunction of the
thermostat controller.
This equipment has been tested and found to
comply with the limits for a Class A digital device
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference when this equipment is
operated in a commercial environment. This
equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instruction manual, may cause
harmful interference to radio communications.
Operation of this equipment in a residential area is
likely to cause harmful interference, in which case
the user will be required to correct the interference
at his/her own expense.
This Class (A) digital apparatus meets all the
requirements of the Canadian Interference-Causing
Equipment Regulations.
Cet appareil numérique de la Classe (A) respecte
toutes les exigences du Règlement sur le matériel
brouilleur du Canada.
YCCS TEC2603-4 BACnet® MS/TP Networked Multi-Stage
Thermostat Controllers
Installation Instructions
TEC2603-4
