7.1
Generator
Chapter 7 - Specifications
This section details the physical and electrical specifications for the U
LTRA
C
ISION
H
ARMONIC
S
CALPEL
System.
Frequency
55.5 Khz (Output)
Dimensions
14” Wide x 8” High x 12” Deep,
Weight
Approximately 20 pounds.
Power Required
GEN01
115 VAC ( ~ ), 60 Hz, 2 Amps, 230 VA Max.
GEN32
230 VAC ( ~), 50 Hz, 1 Amp, 230 VA Max.
Fusing
GEN01
Two, 3 AG Slow Blow 1/4” x 1-1/4”, 2 Amps, located in the power entry module. Three, Internal, 5 mm x
20 mm Slow Blow, 1 @ 1 Amp, 1 @ 0.25 Amps, and 1 @ 1.6 Amps.
GEN32
Six, Internal, 5 mm x 20 mm Slow Blow, 2 @ 0.5 Amps, 2 @ 0.25 Amps and 2 @ 0.63 Amps.
Air Pressure
4.5 psi min.
Air Flow
Approximately 20 liters per minute.
Ventilation
At least 2” in the rear of the unit and the bottom vents should not be obstructed.
Defibrillation Recovery
1 second
Time
Length
HP050, HP051, HPTUV, H1TUV:
HP052, HP053, H2TUV, H3TUV:
Hand Piece - 7”
Hand Piece - 6”
Cable - 10’
Cable - 10.5’
Connectors
Electric - 7 pin.
Electric - 7 pin.
Air - 1/4” CPC.
Air - None
Sterilization
Steam, EO, or STERRAD
®
Steam, EO, or STERRAD
®
Switch
Dual SPST, Normally Off.
Voltage
12 Volts maximum at .010 Amp.
Cable
3 Conductor, Shielded.
Model GEN01
15 Foot, 3 Conductor, 16 AWG, Grounded Hospital Grade Power Cord, terminated with
IEC 320 Connector.
Model GEN32
2 Meter, 3 Conductor, 10A/250VAC ( ~ ), Grounded Hospital Grade Shielded Power Cord, terminated with an
IEC 320 Connector.
Warning: The output isolation transformer shown in Figure 4 should not be allowed to come in contact with any
other wiring or anything else that could bridge the isolation barrier. The insulation on the cable leading from the
isolation transformer to the hand piece connector must be intact.
Environmental Conditions for Transport and Storage
Temperature
-20ºC to +65ºC
Relative Humidity
10% to 100%
Intermittent Operation with a duty cycle of 30 min. ‘ON’, 30 min. ‘OFF’
27
7.2
Hand Piece
7.3
Foot Switch
7.4
Power Cord
7.5
Transport and
Storage
7.6
Mode of
Operation
