John Lewis JLBIWD 1403, Инструкция по эксплуатации

Страница: 6 / 28

6
1 Detergent dispenser drawer
2 Programme selector dial
The programme selector dial is divided into the
following sections:
Cottons, Synthetics, Delicates,Wool (Hand washing)
and Special programmes.
The selector dial can be turned either clockwise or
anticlockwise to select the required wash and drying
programme .
Economy position corresponds to an ENERGY
SAVING programme and Cold to a cold wash.
Before setting the dial to any position ensure that the
machine is turned to the
Off position.
Important!
At the end of the programme the selector dial
must be turned to position Off.
3 “Spin” button
Press this button repeatedly to change the spin speed
or to select position
None , if you want your laundry
to be spun at a speed different from the one proposed
by the washer-dryer. The relevant light will light up.
Spin speed
The following speeds are available for the different
fabrics:
• Cottons, linen: 500/700/900 max 1400 r.p.m.;
• Synthetics and wool: 500/700 max 900 r.p.m.;
• Delicates: 500 max 700 r.p.m.
The Control Panel
90°
Economy 60°
60°
60°+prewash
30°
40°
30°
40°
60°
Off
Child lock JLBIWD1403
40°+prewash
40°Easy iron
Hand wash 30°
Rinse
Synthetic dry
Spin
Cold
Cotton dry
Delicates 40°
Delicates 30°
Drain
Start/Pause
Door lock
Delay start
Wash time
1400
900
700
500
None
Spin Option Extra rinse Drying time Quick
Rinse hold
Stain
Synthetics
W
ool
2 3 4 5 6
9 8 10 1
3 7
11
Cottons
Position «None»
By selecting the option None all the spinning phases
are cancelled and the last rinse water is drained.
If you select this option with programmes for cotton,
synthetics and delicates, the machine will perform
some extra rinses.
4 “Option” buttons
Depending on the programme, different functions can
be combined. These must be selected after choosing
the desired programme and before pressing the
Start/Pause button.
When these buttons are pressed, the corresponding
pilot lights illuminate. When they are pressed again, the
pilot lights go out.
If an incorrect option is selected, the pilot lights flash
for a few seconds and the message
Err is displayed.
Press these buttons to select the following options:
RINSE HOLD: the last rinse water is not emptied
out, to prevent the fabrics from creasing.
At the end of the cycle, the lights corresponding to the
Rinse hold option and the Door lock are on, the
Start/Pause button light goes out and the display
shows a flashing «
0
». The door cannot be opened
because the water must be drained.
To empty out water there are 2 possibilities:
• Select the drain programme and then press the
Start/Pause button:
The water is emptied out without spinning.