John Lewis JLBIDO906, Инструкция по эксплуатации

Страница: 8 / 40

í
8
Building In
Preparing cabinet for fitting of
oven
•
Make sure that the cabinet is the correct size for the
appliance to be fitted (Recommended cabinet
dimensions).
•
If the size is between 565-570mm, then the cabinet
should be modified so that at the screw fixing points
the recommended dimension of at least 560-565mm is
maintained. The modification should ideally be localised
to ensure that after screw fitment the oven is securely
fixed into position.
•
The cabinet must be stable and level by firmly securing
it to the wall or floor. If necessary, make arrangements
to ensure the shelf upon which the oven will rest is
level.
•
When the appliance is installed ensure a minimum gap
of 2mm is maintained between the trim on the bottom
edge of the appliance, and any corresponding door /
panel underneath.
How to finish unpacking
•
Place packed appliance next to the space in which it will
be installed.
•
Remove the appliance packing except for bottom tray,
which should be left in position until the appliance is
ready to be fitted into its cabinet.
Important
It is imperative that the appliance is left in the base to protect
both the appliance and the floor.
•
Ensure the user is given these operating instructions.
Important
Important: Switch off at the mains, miniature circuit breaker and
if appropriate, remove fuse before commencing any electrical
work.
Fitting into the cabinet
Important
Ensure that the oven is switched off at the wall before any
further work is carried out.
•
Using a tape measure establish the internal width of the
cabinet. Refer to recommend cabinet dimensions if
greater than 565mm.
•
Position the appliance in front of the cabinet.
•
Take out all oven furniture before installation to reduce
the weight you need to lift. The oven door should be
taped up to keep it closed whilst lifting.
•
To place the appliance into the cabinetry follow the
procedure below:
Important
Two people will be required to carry out the lifting procedure.
Warning
•
Do not attempt to lift this appliance by the
handle(s).
•
Each person should squat either side of the appliance.
•
Tilt the appliance so that your hands can support the
underside of the appliance.
•
Keeping your back straight, raise the appliance to the
correct height by straightening at the knees.
•
Rest the rear underside of the appliance on the cabinet
floor while your hands support the front.
•
The appliance can be pushed fully into the cabinet. Take
care to avoid fouling the mains lead.
•
Ensure the appliance is central and level.
•
Do not remove spacers fitted behind fixing holes.
•
When the appliance is fully housed screw the stability
screws (supplied with the appliance) into the side of the
cabinet taking care not to distort the side trims. It is
advisable to turn each screw alternatively to avoid
damaging the trims.
•
Switch on the appliance then refer to the operating
instructions.
Fixing points for
stability screws