VIBRATO LFO PARAMETERS (MAIN MODE)
32 | LFOS 1-4 AND VIBRATO LFO
LFOs
Figure 47. LFO Panel
LFOs 1-4 and Vibrato
LFO
Solaris has 5 LFOs, including a special Vibrato LFO, all of
which are available as modulation sources.
Button
Description
Clock Sync
Synchronizes the LFO with the MIDI clock
and changes rate to a MIDI clock-related table
of values.
Offset
Offset reduces the signal and shifts it all into
the positive quadrant. (Useful particularly with
some Shape modulations.)
Retrigger
This restarts the waveshape at the selected
Phase point for every note-on event.
Table 6. LFO panel buttons
LFO 1-4 Parameters (Main Mode)
Page 1 Parameters
Figure 48. LFO Main Mode, page 1
Each LFO supports sine, triangle, ramp, saw, square, and
sample-and-hold (S/H) or random wave shapes. Frequency
is adjustable between 0.000Hz and 500.000Hz. The LFOs
can be synced to the MIDI clock by pressing the
Clock
Sync
button above the LCD screen. When synced to MIDI
clock, the LFO’s frequency is displayed as a division of one
beat.
Recall from “Knob Acceleration and the Shift Button” on
page 16 that the LFO
Rate
knob is configured for fine
control over frequency. To increase the speed at which the
knob sweeps through frequency values, press and hold the
Shift
button while turning the
Rate
knob.
Page 2 Parameters
Figure 49. LFO Main Mode, page 2
Parameter
Description
DelStrt
0.0 ms to 10.0 seconds. Delays the output of
the LFO based on the note-on gate.
FadeIn
0.0 ms to 10.0 seconds. The time it takes to
fade in the LFO output, after the Delay Start is
finished.
FadeOut
0.0ms to 10.0 seconds. The time it takes to
fade out the LFO output after a note/key is
released.
Level
Controls the initial output level of the LFO.
Table 7. LFO Main Mode, page 2 parameters
Vibrato LFO Parameters (Main
Mode)
The Vibrato LFO is hard-wired to the vibrato effect (Pitch
mod) of all 4 oscillators. The Vibrato LFO in Solaris is a
multimode LFO, with the same parameters that come with
the other four LFOs. Added are parameters to disconnect
the
Mod Wheel
, and set a maximum mod amount for the
Mod Wheel
(ModWMax).
Page 1 Parameters
Figure 50. Vibrato LFO Main Mode, page 1
By default, the Vibrato LFO is connected to the
Mod
Wheel
. The
ModWhl
parameter allows the Vibrato LFO to
be disconnected from the
Mod Wheel
. When
ModWhl
is
Off, the Vibrato LFO affects all 4 oscillators’ pitch with full
strength. When
ModWhl
is On, the
ModWMax
parameter
controls how much the Vibrato LFO affects oscillator pitch,
relative to the position of the
Mod Wheel
. The output of any
LFO is controlled overall by the
Level
parameter,
Main
Mode page 2.
If the Level is 0, there will be no output of the LFO,
regardless of any other settings.
Содержание Solaris
Страница 1: ...User Guide Version 1 ...