John Bean EELR369A, Инструкция по установке и эксплуатации

Страница: 37 / 45

- 37 -
Jack Beam Installation, Operation and Maintenance Manual
Fig. 2
Operation
Note: Before lifting a vehicle, operate the jack through a couple of cycles to become
familiar with the controls.
1) Roll jack forward before moving vehicle on lift rack. Be sure vehicle is centered
on rack, apply parking brake and chock wheels.
2) Roll jack
(s) to the vehicle manufacturer’s recommended pick-up points. Extend
lift pad arms to proper lift points. Use lift pad spacers if necessary.
3) Raise jack by pushing on foot pedal on pump.
4) Raise vehicle to desired height.
5) Lower jack onto lock.
6) To lower jack completely, raise off of lock and while holding lock release handle
open lower jack. Push lift pad arms in, remove lift pad spacers (if used). Roll
jack forward before moving vehicle off rack.
Loss of lifting power
If for any reason the lift will not raise off the locks or the locks will not retract, consult
factory authorized personnel.
DO NOT OVERRIDE ANY SAFETY FEATURE IN AN ATTEMPT TO LOWER THE LIFT.
Maintenance
Daily : Inspect jack and its components for damage or excessive wear. Replace parts
as required. See parts list.
Inspect air/hydraulic system for leaks. Check in-line lubricator oil level.
Exhaust water from Filter.
Annually: Check hydraulic pump fluid level. When jack is completely lowered
remove breather plug and check oil level. Oil should be at top of filler
plug hole. Exhaust water from Filter.
IMPORTANT!
Failure to keep lift free of corrosive agents and solvents will lead to reduced service life,
which could result in property damage and/or personal injury. If any problems are
encountered, contact your local service representative 1-800-225-5786