John Bean 48109B, Инструкция по установке и эксплуатации

Страница: 11 / 40

11 of 40
6.3 HYDRAULIC INSTALLATION
ATTENTION: The hydraulic pump system on this lift is not designed to be a load holding
devise. Safety devises must be engaged before proceeding with any vehicle
servicing or system maintenance
NOTE: When working with hydraulics it is important to keep all components clean.
All
hydraulic connections are 37 ½° JIC flares.
1.
Remove the back cover of the Control Console. The power pack is located inside the
console.
2.
Remove the breather filler cap and fill with 20 liters/5.3Gal. of ISO 32 hydraulic fluid (10 weight).
3.
Remove the two (2) hydraulic hoses, one (1) braided hose, and one (1) polytube from the
console. Route all four (4) hoses to the inlet ports located on the left side of the left main
frame assembly Refer to Figure 3.
4.
Locate the two (2) 21' (6401mm) long hydraulic hoses mounted from the back of the console.
Connect the hoses to the two inlet ports of the lift. The inlet ports are located on the left side
of the Left Main Frame Assembly. Refer to Figure 3.
5.
Connect the 21’ (6401mm) long 3/8” braided hose to the inlet on the left baseframe.
6.
Connect one end of the center hydraulic line to the outlet side of the Left Main Frame
Assembly and the other end to the inlet side of the Right Main Frame Assembly. Tighten the
hydraulic line in place so that it runs along the floor giving it a low profile.
IMPORTANT: THE SHIPPING CLAMPS HOLDING EACH MAIN FRAME ASSEMBLY
TOGETHER MUST BE UNBOLTED BEFORE CONNECTING ELECTRICAL POWER.
THERE ARE TWO (2) CLAMPS ON EACH ASSEMBLY.
Figure 3 - Hydraulic Connections