Joerns Healthcare Oxford Advance, Инструкция пользователя и гарантия

Страница: 17 / 84

Oxford ®
Advance
294000.10003 Rev. C
17
English
1. SPREADER BAR: Check the spreader bar for freedom of rotation and
 
swing. Check for wear on the central pivot. Check for firm attachment to
the boom.
2. BOOM: Check the attachment of the boom to the mast. Make sure there
 
is only minimal side movement of the boom and the boom is free to rotate
on the boom bearing.
3. MAST: Check the operation of the mast-locking device. Make sure the
 
mast fully engages into the socket. Check the bottom actuator or hydraulic
unit mounting.
4. ACTUATOR: (electric only): The actuator should require no maintenance

other than checking for correct operation and listening for unusual noise.
5. POWER PACK: (electric only): Check the function of the emergency stop
 
button and emergency down/up. Note: The MINIMUM load required to
manually lower the hoist using the emergency lower function is 30 kg.
6. BATTERIES: (electric only): The batteries are housed in the power pack

and should not require maintenance other than the regular charging as
detailed in the charging instructions. Check that the connections remain clean.
7. HYDRAULIC UNIT: The hydraulic unit should require no maintenance other
 
than checking for correct operation and leakage of hydraulic fluid.
8. LEG ADJUSTMENT: Check the legs operate in both full extensions
 
(inward/outward).
9. CASTORS: Check all castors for firm attachment to the legs. Check for
 
free rotation of the castor and the wheels.
10. CLEANING: Clean with ordinary soap and water and/or any hard surface

disinfectant. Harsh chemical cleaners or abrasives should be avoided as
these may damage the surface finish of the lift. Avoid wetting any of the
electrical parts.
11. LOAD TEST: The load test should be carried out in accordance with the

manufacturer’s test procedures.
12. BASE AND WHEELS: Ensure base is even and level
 
(all four wheels are on the floor).
13. SLINGS: Check for wear and fraying.   
14. LUBRICATION: Oil pivot joints, including mast and boom connections,

pedal assembly, spreader bar joint (only if required
).
15.
FIXINGS: Check all nuts, bolts, screws and fasteners for excessive wear

and for tightness. Replace as required.
*THESE CHECKS SHOULD INCLUDE:
Before Use Initially Service Intervals