www.joerns.com | [email protected]
Joerns
®
Bariatric Beds
Bari10A Model
10
Mattress Support Platform
Width Extenders
The four Mattress Support Platform (MSP)
sections each have a 6" Width Extender on
both sides of the bed (Figure 12).
Release Width Extender by pulling latch
handle along the bottom edge of each MSP
section (Figure 13).
Note:
Width Extenders
lock in either full open or full closed position
and should
only
be used in these positions.
Side Rails move with the Width Extenders.
Caution:
Extend all four sections on each side
prior
to adjusting bed position or Side Rails.
Warning:
Use Width Extenders only after the
resident/patient is safely positioned in the bed.
Failure to do so could result in injury.
Mattress Support Platform
Length Extender
Mattress Support Platform (MSP) Foot Section
has an 8" Length Extender, as does the foot
end of the bed frame. (Figure 14).
Both MSP Length Extender and the Frame
Length Extender latch in the normal and
extended positions.
Using the MSP Length Extender is a two-step
process:
Slide the Frame Extender out first, by
pulling out the latch knob on the side of
the bed frame (Figure 14). Begin carefully
sliding the extender out and release the
latch knob as soon as the extender starts
to slide so that it will automatically latch
again at the extended position. Slowly pull
the extender out until the latch pin clicks
into its detent.
Reach under the center of the MSP Foot
Section and locate the MSP Extender
latch knob (Figure 15). Pull the knob out to
unlatch the Foot Section Extender. Begin
carefully sliding the extender and release
the latch knob as soon as the extender
starts to slide so that it will automatically
latch again at the extended position.
Slowly pull the extender out until the latch
pin clicks into its detent.
Warning: Possible Equipment Damage.
Do
not slide Frame Length Extender past its detent.
Damage to the scale cable will result.
1.
2.
1.
2.
3.
a.
b.
Figure 12
Figure 15 - Photo taken from angle
underneath bed
Figure 14 - Arrow indicates Length
Extension Latch
Warning: Possible Equipment Damage.
Prior to
use of the MSP Length Extender, the Frame Length
Extender must be fully extended and latched. Failure
to do so will result in scale connector damage.
Figure 13
Содержание Bari10A
