Jobsite CN-25, Оригинальная инструкция

Страница: 30 / 39

(2) Grease port
(3) Sprocket
4. Others
Check for fuel leakage and loose fastenings and
damage to major parts, especially handle joints and
guide bar mounting. If any defects are found, make
sure to have them repaired before operating again.
■
Periodical service points
1. Cylinder fins
Dust clogging between the cylinder fins will cause
overheating of the engine. Periodically check the
fins after removing the clutch cover, and then use
pressure air to clean the cylinder fins.
2. Fuel filter
(a) Using a wire hook, take out the filter from the
filler port.
(b) Disassemble the filter and wash with gasoline, or
replace with a new one if needed.
• After removing the filter, use a pinch to hold the end of the suction pipe.
• When assembling the filter, take care not to allow filter fibers or dust inside the
suction pipe.
3. Spark plug
Clean the electrodes with a wire brush and reset the
gap to 0.65mm as necessary.