jobmate JMBMS210G, Инструкция по безопасности и эксплуатации

Страница: 15 / 16

15
WARRANTY
This product is warranted for a 2-year period for
home domestic use from the date of the original
purchase. If found to be defective in materials
or workmanship, the tool or the offending faulty
component will be replaced free of charge with
another of the same item. A small freight charge
may apply.
The battery and charger only have a 1 year
manufacturer’s warranty.
The warranty replacement unit is only made
available by returning the tool to the place of
purchase with a confirmed register receipt.
Proof of purchase is essential.
We reserve the right to reject any claim where
the purchase cannot be verified.
This warranty does not include damage or defects
to the tool caused by or resulting from abuse,
accidents, alterations or commercial or business use.
TROUBLESHOOTING
Problem Probable cause Suggested remedy
motor will not run 1. Switch in OFF position
2. No electrical power at wall
outlet
3. switch broke down
4. motor broke down
5. defective cable 1. Make sure saw is plugged in and switch is
pressed
2. Check circuit breaker or fuse at electrical
panel.
3. replace switch
4. contact service center for Replacing
motor assembly.
5. replace cable
Motor hums but
cannot
run or runs slowly 1.Low voltage
2.Loose electrical connections
3.Wrong gauge wire or length of
extension cord
4.Shorted or open motor winding 1. Check voltage at wall outlet with voltmeter.
2. Check all electrical connections.
3. Check extension cord chart for proper
extension cord usage.
4. contact service center for Replacing
motor assembly.
Flow blows/circuit
breaker trips
repeatedly 1. circuit overloaded
2. Wrong gauge wire or length
of extension cord
3. Motor shorted or seized 1. Disconnect other electrical appliances
from circuit or operate saw on its own
branch circuit.
2. Check extension cord chart for proper
extension cord usage.
3. contact service center for Replacing
motor assembly.