jobmate JMBMS210G, Инструкция по безопасности и эксплуатации

Страница: 7 / 16

7
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction book
carefully.
INTENDED USE
The electro-tool is intended as a stationary machine for
making straight lengthways and crossways cuts in wood.
Horizontal mitre angles of -45° to +45° as well as vertical
bevel angles of 0° to +45° are possible.
ASSEMBLY
WARNING: To prevent the accidental starting that
could cause possible serious personal injury, ALWAYS
assemble all parts to your saw BEFORE connecting it to
the power supply. The saw should NEVER be connected to
a power supply when you are assembling parts, making
adjustments, installing or removing blades, or when not in use.
1. DUST EXTRACTION PORT (SEE FIG. A)
To reduce build up of saw dust and maintain top efficiency of
cutting, the saw dust collection can be achieved by clipping
adjust bag on the dust extraction port (16).
A dust bag is provided for use on your miter saw. To install it,
simply fit the dust bag over the extraction port on the upper
blade guard.
To empty the dust bag, remove it from the dust exhaust port,
open the dust bag by unzipping the slide fastener.
NOTE: To ensure optimal dust collecting, empty the dust bag
when it becomes filled to approximately 2/3 of its capacity.
2. TABLE EXTENSION RAIL (SEE FIG. B1,B2)
To install table extension rail, simply insert ends of extensions
into the holes in either or both sides of the base. Secure them
in place by tightening clamp screw on the base.
The table extension rail is used for supporting the long pieces.
16
17
17
a
19
2
1
1
2
2
18
Fig.A
Fig.B1
Fig.B2
Fig.C1
Fig.E
Fig.D
Fig.C2
Fig.G
Fig.F2
Fig.F1