jobmate 54-2891-8, Руководство пользователя

Страница: 14 / 22

14
VARIABLE SPEED TRIGGER SWITCH
This drill is equipped with a variable speed
ON/OFF trigger switch.
1. To start drill, gently squeeze the trigger
switch (1) (Fig. 6).
NOTE: Drill will turn at its slowest
speed when the trigger switch is
depressed slightly. The drill will turn at
its fastest speed when the trigger
switch is fully depressed.
2. To stop the drill, release the trigger
switch.
NOTE: Drilling at a slow drilling speed for
an extended period of time may cause the
drill motor or the battery pack to overheat. If
the drill or battery get hot, stop drilling and
allow it to cool for at least 15 minutes.
INSTALLING DRILL BITS
WARNING:
Never hold the chuck
body with one hand and use the drill
power to rotate the drill body to loosen
or tighten bits. Serious injury may
result.
1. To open the keyless drill chuck, grasp
and hold the chuck collar (1) with one
hand (Fig. 7). Rotate the chuck body
(2) with the other hand in a counter-
clockwise direction (3) until the chuck
jaws (4) open wide enough to accept
the bit.
2. Insert bit into the chuck the full length
of the jaws. Raise the front of your drill
slightly to prevent the bit from falling
out of the chuck jaws.
3. Tighten the chuck jaws onto the bit by
turning the chuck body in a clockwise
direction.
NOTE: Make sure the bit is properly
aligned in the jaws and NOT at an
angle. An improperly aligned bit could
be thrown from the chuck when the drill
is started. Make sure the chuck jaws
grasp the flat sides of a screwdriver bit.
4. Finish tightening the chuck jaws by
holding the chuck collar with one hand
and firmly tightening the chuck body by
rotating it in a clockwise direction.
NOTE: Hand tighten chuck jaws. Do
NOT use pliers.
Fig. 6
Fig. 7
!
ASSEMBLY & OPERATION