11
Assembly Instructions
5. a
SSembly
i
nStructionS
WARNING
Never plug the power cord (D) into an electrical outlet before
the appliance is fully assembled.
5.1 Installing the handle
1. Line up the holes in the handle with the holes on the top of
the welder.
2. Place a lock washer (1) and a washer (2) onto the welder
handle holes.
3. Insert a screw (3) through the washers and the holes on
the handle and into the top of the welder, and tighten the
screw (fig A).
fig A
JM-1998594-05
1
2
3
5.2 Checking and selecting the appropriate drive
roller
1. Open the wire drive compartment.
2. Loosen the drive tension adjusting knob (1) and lift the drive
tension arm (2) away from the drive roller (fig B).
JM-1998594-06
fig B
2
1
3. Place the wire spool (1) over the spool hub (2). Place the
roller plate (3), spring (4) and wing nut (5) above the wire
spool one by one. Tighten the wing nut (fig C).
JM-1998594-07
fig C
1
2
3
4
5
Note:
The wire should be fed from the bottom of the wire spool
into the drive mechanism.
4. Put one end of the wire (1) from the wire spool into the hole
on the outside edges of the driving mechanism (2) (fig D).
JM-1998594-08
fig D
1
2
Note:
If the wire is already installed in the welder, roll the wire
back onto the wire spool by manually rotating the wire spool
clockwise. Do not allow the wire to come out of the rear end of
the inlet guide tube.
5. Rotate the drive roller cap (1) counter-clockwise and remove
it from the drive roller (2) (fig E).
JM-1998594-09
fig E
1
2
Note:
Check whether the roller groove of the existing drive
roller is suitable for the chosen wire diameter. If not, proceed to
step 6 or step 7.