SECTION 7 - TROUBLESHOOTING
1-877-254-3876
LIFTPOD by JLG
1001070451
1-877-2-LIFTPOD
www.liftpod.com
7-3
Platform will not move when in elevated position - motor starts
Driveshaft interlock is engaged
Push cordless drill on driveshaft down firmly to disengage driveshaft safety inter-
lock.
(If using powerpack) Powerpack shaft not
engaged
Check powerpack charged and in correctly fitted and is fully down and latched
down.
Drive shaft malfunction
Lower platform using manual descent procedure (see Section 4.1). Refer to
Authorized JLG Service Center.
Ropes are loose (ropes must never be loose)
Machine was disassembled without platform
being fully lowered to engage the carriage lock
down latch. Carriage then moved up the mast
loosening the ropes
If carriage is not within 1m (3 ft) of the base of the mast contact Authorized JLG
Service Center. Otherwise follow rope re-tensioning procedure detailed in Section
6.7, point 3. Ensure both ropes are tight and remain so at all times.
Machine does not wheel properly
Retractable Swivel Castor is not properly
deployed
With no load in the platform or on the base - lift the castor deploy handle on front of
base, adjacent to platform gate. Castor should deploy and lift front of machine off
adjustable feet to allow machine to roll easily on rear wheels and front castor.
Castor is damaged
Replace castor.
TROUBLE
PROBABLE CAUSE
REMEDY
FS.book Page 3 Wednesday, February 11, 2009 11:54 AM
