JLG E450A, Руководство по обслуживанию и ремонту

Страница: 399 / 480

SECTION 6 - JLG CONTROL SYSTEM
3121714 6-83
99 19 GROUND SENSOR REF VOLTAGE OUT OF RANGE The UGM has detected reference voltage is out of
range: 2.3V < Reference Voltage <
2.7V(debounced for 100ms) Power cycle
99 20 PLATFORM SENSOR REF VOLTAGE OUT OF
RANGE The UGM detects that its reference voltage being
reported by PM out of range (4.8V < voltage <
5.2V); debounced for 100ms Power cycle
99 21 GROUND MODULE FAILURE - HIGH SIDE DRIVER
CUTOUT FAULTY The UGM footswitch input J7-15 is LOW Power cycle
99 22 PLATFORM MODULE FAILURE - HWFS CODE 1 The PM detects that its V(low) FET has failed and
reports this fault to the UGM Power cycle
99 24 FUNCTIONS LOCKED OUT - MACHINE NOT CON-
FIGURED The machine is powered up and no model has been
selected yet in the MACHINE SETUP menu Power cycle
99 27 GROUND MODULE CONSTANT DATA UPDATE
REQUIRED The UGM detects one of the following conditions
when software type is ‘P’ or ‘B’: The Version Verifi-
cation Word #1 or the Version Verification Word #2
values located in the constant data sector of flash
memory (found on constant data spreadsheet tab
pstConstantDataVersion) do not match the values
located in the code area of flash memory. The Ver-
sion Major value located in the constant data sector
of flash memory (found on constant data spread-
sheet tab pstConstantDataVersion) does not match
the value located in the code area of flash memory. A different application code or constant data ver-
sion is programmed so that the values match;
Power cycled
99 44 CURRENT FEEDBACK GAINS OUT OF RANGE One or more of the current feedback gains that are
calculated and written to flash memory during the
JDES manufacturing test process are detected as
being out of range Power cycle
99 45 CURRENT FEEDBACK CALIBRATION CHECKSUM
INCORRECT The current feedback gains checksum that is calcu-
lated and written to flash memory during the JDES
manufacturing test process is detected as being
incorrect Power cycle
99 49 MACHINE CONFIGURATION OUT OF RANGE -
CHECK ALL SETTINGS UGM has detected an anomaly in EEPROM with
regard to the Machine Setup configuration. Power cycle
99 77 LSS CORRUPT EEPROM MACHINE SETUP ->LOAD SYSTEM ≠ NO and one of
the following conditions:
UGM determines LSS-stored values for Unloaded
weight in Indirect 0x100≠ 0x108 or UGM deter-
mines LSS-stored values for Accessory weight in
Indirect memory≠ 0x10A; UGM determines LSS-
stored checksum1 in memory ≠ checksum 2 in
memory Power cycle
99 79 FUNCTIONS LOCKED OUT - GROUND MODULE
SOFTWARE VERSION IMPROPER Ground software has been installed on a UGM with
a ST10F274 processor (Hardware Rev < 6), which
does not have guaranteed flash storage in the sec-
tor where Constant Data is written. Power cycle
99 86 GROUND MODULE VLOW FET FAILURE VLow FET determined to be failed on Startup; UGM
unable to read high-sensing inputs. Power cycle
99 167 PUMP COMMAND ERROR Master Traction Module determines that an incon-
sistency has occurred between the Pump Enable
bits and the Pump commands; Pump enable bit =
set, but Pump Command = 0 Power cycle
Table 6-17. Diagnostic Trouble Codes
DTC Cat DTC Num DTC Text Fault Description Solution