JLG E450A, Руководство по обслуживанию и ремонту

Страница: 222 / 480

SECTION 5 - BASIC HYDRAULIC INFORMATION & SCHEMATICS
5-64 3121714
2. Use a soft mallet to tap a new wiper seal into the appli-
cable cylinder head gland groove. Install the new retain-
ing ring into the applicable cylinder head gland groove.
3. Place a new o-ring and backup seal in the applicable
outside diameter groove of the cylinder head.
4. Install o-ring onto the cylinder rod. Carefully install the
head gland on the rod, ensuring that the wiper and rod
seals are not damaged or dislodged. Push the head
along the rod to the rod end.
5. Place a new o-ring and backup rings in the inner piston
diameter groove.
6. Using suitable protection, clamp the cylinder rod in a
vise or similar holding fixture as close to piston as possi-
ble.
7. Carefully thread the piston on the cylinder rod hand
tight, ensuring that the o-ring are not damaged or dis-
lodged.
8. Thread piston onto rod until it abuts and install the
retainer. Refer Figure 5-27.
9. Tread piston onto rod until it abuts and install the lock
nut. Refer Figure 5-28.
10. Remove the cylinder rod from the holding fixture.
11. Place new piston seal and wear rings in the outer piston
diameter groove. (A tube, with I.D. slightly larger than
the O.D. of the piston is recommended to install the
solid seal).
12. Position the cylinder barrel in a suitable holding fixture.
EXTREME CARE SHOULD BE TAKEN WHEN INSTALLING THE CYLINDER ROD,
HEAD, AND PISTON. AVOID PULLING THE ROD OFF-CENTER, WHICH COULD
CAUSE DAMAGE TO THE PISTON AND CYLINDER BARREL SURFACES.
13. With barrel clamped securely, and while adequately sup-
porting the rod, insert the piston end into the barrel cyl-
inder. Ensure that the piston loading o-ring and seal ring
are not damaged or dislodged.
14. Continue pushing the rod into the barrel until the cylin-
der head gland can be inserted into the barrel cylinder.
15. Screw the cylinder head gland into the barrel using a
spanner wrench.
16. After the cylinder has been reassembled, the rod should
be pushed all the way in (fully retracted) prior to the re-
installation of any holding valve or valves.
17. Install the counterbalance valves in the rod port block.
Torque as shown in Figure 5-27. and Figure 5-28.
Figure 5-32. Wiper Seal Installation
3&5"*/*/(
3*/(
8*1&3
4&"-
$:-*/%&3
)&"% ."--&5
Figure 5-33. Installation of Head Seal Kit
&</,1'(5
+($'
%$&.83
5,1*
25,1*
WEAR
RING
WEAR
RING
PISTON
SEAL
O-RING
Figure 5-34. Piston Seal Kit Installation