JLG 3394RT, Руководство по техническому обслуживанию

Страница: 95 / 228

SECTION 3 - CHASSIS & SCISSOR ARMS
3121133 – JLG Sizzor – 3-59
5. Oil level must be between the "FULL" and "ADD"
marks.
6. If the oil level is below the "ADD" mark, proceed to
Step 7 and 8 and reinstall the dipstick into the dip-
stick tube.
7. Remove the oil filter cap from the valve rocker arm
cover.
8. Add the required amount of oil to bring the level up
to but not over "FULL" mark on the dipstick.
9. Reinstall the oil fill cap to the valve rocker cover and
wipe away any excess oil.
Changing The Engine Oil
NOTICE
WHEN CHANGING THE OIL, ALWAYS CHANGE THE OIL FILTER.
CHANGE OIL WHEN THE ENGINE IS WARM FROM OPERATION
AS THE OILS WILL FLOW FREELY AND CARRY AWAY MORE
IMPURITIES.
To change the oil use the following steps:
1. Start the engine and run until it reaches normal
operating temperature.
2. Stop the engine.
3. Remove the drain plug and allow the oil to drain.
4. Remove and discard the oil filter and its sealing ring.
5. Coat the sealing ring on the filter with clean engine
oil and wipe the sealing surface on the filter
mounting surface to remove any dust, dirt and
debris. Tighten the filter securely (follow the filter
manufacturers instructions). Do not over tighten.
6. Check the sealing ring on drain plug for any dam-
age, replace if necessary, wipe the plug with a clean
rag, and wipe the sealing surface on the pan and
reinstall the pan plug. Do not over tighten.
7. Fill the crankcase with oil.
8. Start the engine and check for oil leaks.
9. Stop the engine and check the oil level to insure the
oil level is at "FULL".
10. Dispose of the oil and filter in a safe manner.
Figure 3-26. Engine Oil Dip Stick
Property of American Airlines