JL Audio Fathom SA-600W, Руководство пользователя

Страница: 15 / 40

Page 15 | Fathom SA -600W
High level inputs
This feature is included for convenience when needing to connect the SA-
600W to a receiver that only offers speaker level outputs. It is not the preferred
method when a line-level signal is available.
To use this feature, simply connect the full-range speaker outputs of your
receiver to the “HIGH LEVEL INPUTS” plug of the SA-600W, in parallel with
the main speakers. In this application, the main speakers will remain full-range
and their sound will not be affected by the connection to the SA-600W.
The “HIGH LEVEL INPUTS” consists of an input connector and removable
plug with captured-wire receptacles. Standard speaker cable, up to 12 AWG (3
mm
2
), can be used and connected to the removable plug by backing out each set
screw, inserting the bare end of each speaker wire, taking care not to short any
wire to another, and tightening the set screw. Note: The mating connector is
keyed to fit the input jack in one direction only.
“HIGH LEVEL INPUTS” connector (from left to right):
1. (-) Right Channel Negative
2. (+) Right Channel Positive
3. (-) Left Channel Negative
4. (+) Left Channel Positive
Input Impedance: 4.4 kΩ
Note: It is vital to observe correct electrical polarity of each channel’s
input signal. Failure to do so can result in no output, loss of signal and
poor performance.
Wireless JLINK™ Port
Your SA-600W includes a “WIRELESS JLINK™ PORT” receptacle that can be
used with a JL Audio JLINK™ TRX system (sold separately). The JLINK™ TRX is
a high-fidelity audio transmitter & receiver system, capable of wirelessly sending
audio signals up to 100 feet away (30 meters). Using a JLINK™ TRX will eliminate
the need to run physical signal cables from your receiver or preamp/processor’s
line-level outputs to the line-level inputs of your SA-600W. Instead, the SA-600W
will wirelessly receive audio signals into its “WIRELESS JLINK™ PORT” directly
from the JLINK™ receiver’s cable connection.
Note: Use of the JLINK™ TRX system requires line-level outputs from your
receiver or preamp/processor. Speaker level outputs are not compatible.
FUSE
FUS
E
Warranty void if serial number is removed, altered or defaced.
120 V ~ 60 Hz F 6A H 250V
FUSE
FUS
E
Warranty void if serial number is removed, altered or defaced.
120 V ~ 60 Hz F 6A H 250V