JL Audio Fathom SA-600W, Руководство пользователя

Страница: 10 / 40

| Fathom SA -600W Page 10
PLACEMENT CONSIDERATIONS
The SA-600W is designed to be “built-in” friendly. All typically needed
controls are located on the front panel. An SA-600W can be easily integrated into
an equipment rack or custom cabinetry by following a few simple guidelines.
1) Allow adequate open space around the SA-600W’s side-mounted heatsinks for
adequate cooling. Also allow space behind the amp for connector clearance.
2) While the SA-600W generally runs only warm during spirited operation, we do
recommend that adequate heat vents are included in any custom cabinet which
encloses the SA-600W. A pair of 3 inch (7.5 cm) diameter vents near the bottom
of the cabinet and near the top of the cabinet, will allow cool air to circulate over
the heatsinks of your SA-600W keeping it cool and happy.
Rack Mount : The SA-600W ships with rack ears pre-attached for installation in a
standard 19-inch equipment rack.
Table-Top : The SA-600W includes rubber feet for table-top installations.
Simply remove the hex screws that attach the rack ears to the SA-600W
and screw the rubber feet into threaded holes in the bottom of the amplifier
case. WARNING: The rubber feet attach using M6-1.0 x 10mm screws. If
lost or misplaced, only replace with the same type and length of screws.
Using longer screws will cause damage to the internal circuit board.
Rack Mount
Table-Top