PAGE 127 of 185
CX0540 Rev 00.1
3.
Once the cable is placed the entire length of tube, bring the zipper from
the opposite end to meet at any point in the middle.
When necessary, the two zippers may be opened to allow any cables to be
routed out of the tube.
5.12.2.3 Clamp Setup
In the event the tube becomes
disconnected from the cable
management clamp, follow these
instructions to reattach the tube and
clamp.
Loosen the clamp screw using the
supplied 3 mm hex driver. Slide the
clamp around the tube first and
then slide the tube around the
outside of the cable management
mount
(Fig. 312)
. Align the tube
opening and the cable
management clamp opening.
Slide the clamp over the tube and
cable management mount pinching
the tube in between
(Fig. 313)
.
Tighten the clamp screw
(Fig. 314)
.
Fig. 310 - Zip opposite end
Fig. 311 - Flexible routing
Fig. 312 - Slide tube around mount
Fig. 313 - Slide clamp onto mount
Fig. 314 - Tighten clamp screw
