Push spacer into lightly greased rubber cup & mount front wheel by sliding the hub lug into the
slot on the left fork. Push the axle thru’ the hub & torque up the castle nut to 29-39 N.m (21-29
lbf-ft) & install supplied large split pin. This is tight but DO NOT OVER TORQUE [Note if you
don’t have a torque wrench this is equivalent to 10-12 kgs force using a 30cm long socket set
handle OR 32-44 lbs force using an 8” long ring spanner].
Connect front brake cable as above.
Remove machine screw apply grease & connect the speedometer cable. Reinstall machine
screw using a couple of drops of Loctite.
Remove prop from under the engine crankcase & the NZ50 is now resting on the front wheel &
centre stand.
Lift up body of bike from the rear wheel & connect bottom of rear shock absorbers loosely to
bolts using supplied chrome bonnet nuts & washers.
www.NZmoto.com
Page 4 of 10
Machine screw
Grease
