Jetter JM-208-480-OEM, Руководство пользователя

Страница: 78 / 128

9 Diagnostics
78 Jetter AG
F 05 Current overload Output current was
greater than 2.5 x
rated current. – Immediate
motor power
disable
– Check motor cable for
short circuit between
lines or lines to earth
– Check the current
controller parameters. If
necessary, check the
parameters.
– Acknowledge failure
F 06 Ballast resistor
overload The ballast resistor
has been
overloaded – Immediate
motor power
disable
– Let the amplifier cool
down
– When the motor has
cooled down,
acknowledge failure
– Reduce regeneration
power
F 07 Amplifier
overtemperature The amplifier has
reached the
maximum
temperature – Immediate
motor power
disable
– Let the amplifier cool
down
– When the motor has
cooled down,
acknowledge failure
– Reduce power of the
drive system
F 08 Motor
overtemperature The motor has
reached the
maximum
temperature
Also refer to "Built-
In Thermal Sensor"
on page 39 – Immediate
motor power
disable
– Let the motor cool down
– When the motor has
cooled down,
acknowledge failure
– Reduce the average
load of the motor
F 09 Encoder failure Encoder breakage
or initialization
error – Immediate
motor power
disable
– For extended
diagnostics purposes
use motion setup
– Check the encoder line
and all plug-in
connections
– Acknowledge failure
F 10 Overspeed The actual shaft
speed has
exceeded a value
of 1.25 x maximum
speed – Immediate
motor power
disable
– Check motor and
encoder connections
– Controlling the speed
parameters. Change
parameters if
necessary.
– Acknowledge failure
F 11 Current
overrange A current
temporarily too
high has been
detected – Immediate
motor power
disable
– Reduce Kp of the
current controller by 10
to 20 %
– Acknowledge failure
Fault Message Table JetMove 208-480
Fault
Number Type of Fault Description Response to
Faults Troubleshooting