JetStor FX Series, Руководство по оборудованию

Страница: 50 / 117

34
The following content and images are detailed steps for installing a host card into the
system.
 Remove the controller from the system chassis.
The following image and table are the introduction of the mechanical components of a
controller module.
Figure 3-10 Mechanical Components of the Controller Module
Table 3-6 Mechanical Components of a Controller Module
Number Description
1 Release Lever
2 Screw

The following content and images are detailed steps for removing the controller module
from the system chassis.

Use a Phillips screwdriver to loosen the thumb screws on each release levers.
 Pull down both levers at the same time and then pull out about half length of the
controller module by holding two release levers.
 Use one hand to hold one end of the controller module (the side with release levers) and
the other hand hold the bottom of the controller; pull out the controller module until it is
free from the system chassis.