JetCat RX Series, Руководство пользователя

Страница: 54 / 54

PAGE 54 of 54
Reset to Default Value
The Ecu can be reseted to default values by following descrption:
Press and keep presses the
„Select Menu“ key on the GSU
, switch ond the ECU
(receiver). Insted of
„Select Menu“ Taste auf der GSU, its also possible to press the little
key of the LED-board.
The LED’s indicate the following blink sequence :
LED Blink Sequenz
Standby
     
(yellow)
Pump running
          
(red)
OK
     
(green)
The dispaly of GSU indicate simultanously :
Release Key to
„Learn RC“
While this sequence hold the key
„SelectMenu“don’t realease it !!!!
After awhile of ca. 15 seconds the LED’s indicat the folowing blink sequence:
LED Blink Sequenz
Standby
     
(yellow)
Pump running
          
(red)
OK
     
.... (green)
While this sequence hold the key
„SelectMenu“don’t realease it !!!!
Releas the key not before the LED’s indicate following sequnce:
LED Blink Sequenz
Standby
     
(gelb)
Pump running
          
(rot)
OK
     
.... (grün)
Simultanously the Display of GSU indicate:
“Release key to Reset System”
Now release the key to run the reset.
After a reset ist neccessary to:

Learn in RC

Run the Temperature calibration