PAGE 36 of 54
Smoker valve
The ECU can directly control a smoker valve for injection of smoke fluid (e.g. diesel oil) in the exhaust
blast. The smoker valve is of the same type as used for the fuel shut off .(Order No.:61106-00).
The function of the smoker valve can be defined in the “Limits menu”
(Parameter: „SmokerValve Ctrl“)
The possible option for the parameter „SmokerValve Ctr” are:
Option
Description
DISABLED
The smoker valve is not used,
valve is always closed !
Open if AuxSw=0
Smoker-valve is opened if the AUX-Switch (3-Pos. switch) is brought
into the
lower
position (“OFF”-Position) and the turbine is running.
To be able to use this function it is necessary, that the AUX-channel is
activated, this is the parameter „AUX-channel func“ (see below) must
not be adjusted to „NOT USED“.
Open if AuxSw=2
Smoker-valve is opened if the AUX-Switch (3-Pos. switch) is brought
into the
upper
position (“AUTO-OFF”-Position) and the turbine is
running.
To be able to use this function it is necessary, that the AUX-channel is
activated, this is the parameter „AUX-channel func“ (see below) must
not be adjusted to „NOT USED“.
Smoke
Each JetCat Bus-pump can be switched between fuel
– and smoke pump, factory setting is fuel pump.
To change the setting switch off receiver, connect
only
the pump you want to adjust (
RXi,
disconnect the
Power-Bus cable during this procedure ) press the key
Change Value
and switch on the RC
.
Release the
key
Change Value
once in the display appears:
By pressing
the” – “key the connected pump is set to smoke pump and will be detected by the system as
such. Now connect both pumps and ECU as shown in the next picture. During the next power up either
pump will be detected and logged by the system.
It’s recommended to connect the fuel pump first to the ECU and the smoke pump in series to the fuel
pump.
Certainly the pump can be reversed to fuel pump by running this procedure again but press the
“+” key
Attention!
Injekt the smokefluid rear the thrust tube to avoid flash fire of unburned fuel.
Содержание RX Series
Страница 15: ...PAGE 15 of 54 Complete System Connection Diagram RXi...
Страница 16: ...PAGE 16 of 54 System Connection RXi Photo To fueltank To receiver...
Страница 29: ...PAGE 29 of 54 Flashing E EGT sensor defective Last Off Condition Low RPM shut off from previous run...
Страница 38: ...PAGE 38 of 54 Connection Diagram of the Smoke System...