INF
jetboards.mx
-
USER AND SAFETY MANUAL - kymera
FINISHING RIDE
- Adult supervision is required.
At the end of your ride proceed slowly back to shore watching out for obstructions. Once to
shore maneuver the board back onto land. Once sitting securely on land open the front hatch
and power off the battery. Allow a few seconds after switching off until the LEDs on the controller
turn off. Next remove the power plug and lower the locking bar.
Once free lift the front of the battery while sliding forward, reversing the installation process.
Once the battery is removed from the board any water in the hull can be drained by standing the
board up on end and board is ready to be transported.
KYMERA maintenance
- Adult supervision is required.
Properly cleaning and maintaining your
Kymera body board
is important to the longevity of the
product.
Do not ride
Kymera
in shallow water, or in water with high particulate (sand/dirt).
After each use, remove battery and drain the board completely. Spray board with clean water
inside and out. Avoid submerging electronics by tipping the board nose up allowing water to
drain out of the rear.
With the battery unplugged and removed, ensure that the jet-pump and impeller are clean and
clear. Carefully remove foreign material if any.
Proper lubrication is critical to performance and should be performed at regular monthly
intervals when in regulat use and before storage (Lucas Oil 10682 Marine Grease or
comparable). When operatinf in saltwater weekly or more is advised to clear any trapped
moisture. There are two grease fitting (1) inside the rear hatch and (1) inside the pump. Make
sure to loosen the grease gun collect to make disconnection easier. Do not forcefully remove the
grease hose damage may result. If the gun should become stuck continue loosening the collect
until it releases.
10
