Jet XACTA JTAS-12-DX, Инструкция по эксплуатации и каталог запасных частей

Страница: 12 / 28

12
7.10 Installing riving knife
•
Hardware: riving knife
•
Tool: straight edge
1. Loosen handle (E, Figure 9).
2. Push tabs of riving knife into block as far down
as it will go and tighten handle.
Figure 9
3. Install blade (not provided).
4. Lay a straight edge against side of riving knife
and blade (Figure 10). Make sure it contacts
flat surface of blade, not an offset tooth.
5. If knife and blade are not flush, note the
direction in which riving knife needs to move to
align. Remove riving knife and adjust any of
four set screws (F, Figure 11).
6. Reinstall riving knife and check alignment
again. Repeat as needed until surfaces are
flush.
Figure 10
Figure 11
7.11 Table insert adjustment
•
Hardware: Table insert
•
Tools: Straight edge, 2.5mm hex key
Install table insert and make it flush with table by
turning any of six leveling screws (G, Figure 12)
while verifying with a straight edge.
Figure 12