Jet XACTA JTAS-12-DX, Инструкция по эксплуатации и каталог запасных частей

Страница: 11 / 28

11
Figure 5
7.6 Installing motor cover
1. Install motor cover by aligning pins on cover
with barrels on cabinet (A, Figure 6).
2. Fasten cover by pulling out latch (B, Figure 6),
closing door, and releasing latch.
Figure 6
7.7 Installing handwheel
•
Hardware: Handle and handwheel, lock knob
•
Tool: 3mm hex key
1. Remove tape holding key to shaft.
2. Line up key on shaft with keyway in handwheel
and slide handwheel (C, Figure 7) onto shaft.
3. Tighten set screw on handwheel hub securely
to hold in place.
4. Insert lock knob (D, Figure 7) into center hole
in shaft and rotate in clockwise direction.
Note: Rotate handwheel in order to free the
packing below the motor.
Figure 7
7.8 Installing storage hooks
•
Hardware: Socket head cap screws and
washers (already in cabinet holes)
•
Tool: 5mm hex key
Install small hook (E, Figure 7) in upper hole for
miter gauge storage. The larger hooks (F, Figure 7)
are installed in the lower holes for fence storage.
7.9 Installing blade (not provided)
When installing or changing
saw blade, always disconnect saw from power
source.
Failure to comply may cause serious
injury.
•
Tool: Arbor wrench
1. Raise blade arbor fully with front handwheel
and lock it at zero degrees by tightening lock
knob in middle of handwheel.
2. Remove arbor nut (A, Figure 8) and flange (B).
3. Place blade on arbor shaft, making sure the
teeth point down toward front of saw. Reinstall
flange and arbor nut.
4. Rotate arbor until hole (C) lines up with arbor
lock pin (D). Push pin into hole and hold.
5. Tighten arbor nut with provided wrench.
Figure 8