10
After a days use push the sliding table
all of the way forward and backward.
Remove rust from the table e.g. with
WD-40
and a Scotch-Brite™ Hand
Pad.
Never smoke while cleaning the
machine, and especially when using
petrol, kerosene or other inflammable
products.
This could lead to an explosion and
serious burns for the operator.
All protective and safety devices must
be re-attached immediately after
completed cleaning, repair and
maintenance work.
Defective safety devices must be
replaced immediately.
Check saw blades regularly for faults.
Replace a defective sawblades
immediately.
A worn table insert must be replaced.
The motor break works mechanically
and will gradually wear.
If breaking time should exceed 10
seconds the break unit must be
replaced.
Break unit replacement:
Disconnect the machine from the
power source, unplug.
Remove the rear cabinet cover.
Remove the motor fan cover.
Remove the fan.
Replace the worn break unit (Jet spare
part No: AB200702).
Reinstall fan and covers.
Main drive belt tensioning:
Check regularly the condition of the
belt and, if necessary, tighten or
replace.
Remove the rear cabinet cover.
Tilt the sawblade to 45°
Loosen the 3 motor plate lock bolts
(A, Fig 17).
Tension the belt by pushing the motor
down.
Fig 17
Make sure the belt is not over
tensioned, because this could lead to
damage of the saw arbor and
bearings.
Tighten the bolts.
Reinstall cabinet cover.
9. Trouble shooting
Motor doesn’t start
*No electricity-
check mains and fuse.
*Defective switch, motor or cord-
consult an electrician.
*Overload has reacted-
Wait and start again.
*Lower sawblade cover still open-
Close cover correctly.
Machine vibrates excessively
*
Stand on uneven floor-
adjust levelling screws for even
support.
*dust on saw flanges-
clean saw arbor and flanges.
*defective sawblade -
replace sawblade immediately
*Bad Poly-V-belt-
replace Poly-V-belt
Cut is not accurately square
*Stops not adjusted correctly-
check with square and adjust stops.
Material binds blade when
ripping
*Fence not aligned with sawblade-
check and adjust rip fence.
*Wrapped wood-
select another piece of wood.
Material kicked back from
blade
*Fence not aligned with sawblade-
check and adjust rip fence.
*Raving knife not in place-
high danger, mount immediately with
guard.
Cutting surfaces is bad
*Wrong sawblade used
*Blade mounted backwards
*resin collection on sawblade
*sawblade is dull
*workpiece inhomogeneous
*Feed pressure too high-
Do not force the workpiece.
Blade does not raise or tilt
*Sawdust in mechanisms-
clean and regrease.
Sliding table does not move
*Sawdust in bearing guides-
wipe out any sawdust.
Breaking time exceeds 10 sec.
*Motor break worn-
replace motor break unit
10. Environmental protection
Protect the environment.
Your appliance contains valuable
materials which can be recovered or
recycled. Please leave it at a
specialized institution.
11. Available accessories
Stock number 708118
Universal mobile base 250kg
Stock number 708119
Universal mobile base 500kg
Stock number 10000063
Outrigger table 570x730mm with
telescopic arm and pull out mitre
fence 2500mm (for JTS-700L)
Fig 18
Refer to the JET-Pricelist
for various accessories.
12. Safe operation
See appendix A (on the last pages of
this operating manual)
A.1.: Ripping
A.2.: Ripping of narrow stock
A.3.: Crosscutting on ripfence
A.4.: Use of push wood handle