Jet JMS-10SCMS, Инструкция по эксплуатации и каталог запасных частей

Страница: 17 / 36

17
Adjusting Fence Squareness
1. Loosen four fence locking screws (D, Fig. 18).
Note: two locking screws to each fence.
2. Lower the cutting arm and lock in position.
3. Using a square , lay the heel (B, Fig. 17 of the
square against the blade (A) and the ruler (C)
against the fence (D).
4. Adjust the fence 90° to the blade and tighten
the four fence locking screws.
If the saw has not been used
recently, recheck blade squareness to the fence
and readjust if needed.
5. After fence has been aligned, using a scrap
piece of wood, make a cut at 90º then check
squareness on the piece. Readjust if
necessary.
Positive Stop Miter Angle Adjustment
Referring to Figure 19:
1. Unlock the miter table by lifting up on the quick-
cam miter table lock (A).
2. Raise the positive stop locking lever (C) up; at
the same time grasp the miter handle (B) and
rotate the miter table left or right to the desired
angle.
3. Release the positive stop locking lever (C) and
set the miter at the desired angle making sure
the lever snaps into place.
Note: There are ten positive stops into which
the lever will lock.
4. After the angle is selected, press down on the
quick-cam miter table lock (A).
Quick-cam Miter Table Lock Operation
If a miter angle required is not one of ten positive
stops, the miter table can be locked at any angle
between these positive stops by using the quick-
cam miter table lock.
Referring to Figure 19:
1. Unlock the miter table by lifting up on the quick-
cam miter table lock (A).
2. Raise the positive stop locking lever (C) up; at
the same time grasp the miter handle (B) and
rotate the miter table left or right to the desired
angle.
3. Release the positive stop locking lever (C).
4. Press down on the quick-cam miter table lock
(A) until it locks the miter table in place.
Figure 17
Figure 18
Figure 19