Jet JMS-10SCMS, Инструкция по эксплуатации и каталог запасных частей

Страница: 25 / 36

25
Bevel/Miter Settings
Settings for standard crown molding lying flat on
compound miter saw table.
Note: The chart below references a compound cut
for crown molding only when the angle between the
walls equals 90°.
Type of Cut Key
Bevel
Setting Miter
Setting
Procedure
Inside corner – Left
Side IL 33.9° 31.6°
Right
1. Position top of molding against fence.
2. Miter table set at RIGHT 31.6°.
3. LEFT side is finished piece.
Inside corner –
Right Side IR 33.9° 31.6° Left 1. Position bottom of molding against fence.
2. Miter table set at LEFT 31.6°.
3. LEFT side is finished piece.
Outside corner –
Left Side OL 33.9° 31.6° Left 1. Position bottom of molding against fence.
2. Miter table set at LEFT 31.6°.
3. RIGHT side is finished piece.
Outside corner –
Right Side OR 33.9° 31.6°
Right
1. Position top of molding against fence.
2. Miter table set at RIGHT 31.6°.
3. RIGHT side is finished piece