Jet JDS-12X-M, Руководство по эксплуатации

Страница: 7 / 26

Fig 4
Warning:
Never apply the disc brake while the machine is “ON”.
Damage to the brake or disc may occur.
6. Machine operation
Correct operating practice :
Always support the workpiece with the table.
Feed the workpiece straight across the machine table, holding
your fingers close together, guiding the workpiece with the palm
of your hands (Fig 5).
Fig 5
The use of the mitre gauge is recommended (Fig 6).
Fig 6
When working complex shapes, make jigs and guides to guide
the workpiece properly and safely.
Support long workpieces with helping roller stands.
Warning :
Avoid kickback by sanding in accordance with directional arrow.
Sand on downward side of disc only.
Sanding on the upward side could cause the workpiece to fly up
(kickback) causing injury!
Never sand with the disc safety guard not in place.
To avoid jamming the workpiece or fingers between the table
and sanding surface, maintain a 1.5mm maximum clearance
between the sanding disc and table.
Bevel sanding :
The work table can be tilted from 0 to +45 degrees for bevel
sanding. Loosen the table lock knob (K, Fig 7) to tilt the
worktable to desired angle.
Fig 7
7. Setup and adjustments
General notes:
Setup and adjustment work may only be carried out after the
machine is protected against accidental starting by pulling the
mains plug.
Make sure all levers and locking handles are tightened before
operating the machine.