Jet Elite ECB-1833DMEVS, Инструкция по эксплуатации и каталог запасных частей

Страница: 10 / 52

10
Horizontal Band Saw
10.0 CONTROLS
Refer to Fig. 10-1.
The control box arm has wide swing adjustment for conve-
nient positioning. The button functions are as follows.
Emergency Stop Button (A) – Press to immediately stop
all machine functions. Rotate clockwise to disengage.
Coolant Switch (B) – Turn switch to “I” to turn on coolant
fl ow. Turn switch to “O” to stop coolant fl ow. Flow is
regulated at the individual valves.
Stop Button (C) – Press to stop operation cycle.
Saw Head Movement (D) - Raises or lowers saw head.
Manual/Auto (E) - When Manual is selected, saw head
will remain down after cut. When Auto is selected, saw
head will return to raised position after cut.
If the bulb is out, lamp will not light, but machine
may still have power.
Hydraulic Start Button (F) - Press this fi rst to activate all
other functions on the panel.
Power Indicator Light (G) – Illuminated whenever
machine is connected to power.
Main Motor Button (H) – Press to start motor and cutting
operation.
Vise Positioning (I) – Turn switch to position vise table
forward or back . CAUTION: Raise saw frame higher than
vise before moving vise table, to avoid machine damage.
Also, see note in Fig. 11.7 concerning removable table.
Vise Clamping (J) - Activates or releases clamping
action of the vise. Turn to the right and hold until clamping
pressure reaches 10-12 kg/cm².
Digital Readout (K) - Indicates blade speed during
machine operation, cutting angle when machine is
stopped.
Blade Speed (L) - Adjusts blade cutting speed; turn
clockwise to increase speed.
Angle Adjust Switch(M) - Turn to adjust cutting angle.
CAUTION: Be sure to raise saw frame higher than vise
height before moving angle to avoid machine damage.
Angle Rapid Adjust (N)
- Press to quicken the angle
adjustment process. (Switch M must be turned at the
same time.)
Feed Rate Control (O) – Sets saw head speed of
descent, and thus the amount of pressure placed on the
workpiece by the blade. Turn counterclockwise to increase
feed rate.
Check with a qualifi ed electrician or service
personnel if the grounding instructions are not
completely understood, or if in doubt as to whether
the tool is properly grounded. Failure to comply may
cause serious or fatal injury.
9.0 ELECTRICAL CONNECTIONS
9.1 GROUNDING INSTRUCTIONS
The ECB-1833DMEVS Band Saw is prewired for 230V, 3
phase, or 460V, 3 phase. Confi rm that power available at
the saw’s location matches that for which the saw is wired.
The machine is not provided with an electrical plug; it can
be “hardwired” directly to a service panel.
Permanently connected tools: This tool should be con-
nected to a grounded metal permanent wiring system; or
to a system having an equipment-grounding conductor.
Make sure a disconnect is available for the operator.
During hard-wiring of the machine, make sure the fuses
have been removed or the breakers have been tripped
in the circuit to which the band saw will be connected.
ALWAYS FOLLOW PROPER LOCK-OUT/TAG-OUT PRO-
CEDURES.
Electrical connections must be made by a qualifi ed
electrican in compliance with all relevant codes.
This machine must be properly grounded to help
prevent electrical shock and possible fatal injury.
Fig. 10-1