15
4
–
TROUBLESHOOTING
THE
DISHWASHER
DOES
NOT
WORK ?
1-
Verify main water supply inlet is
correctly connected, open and free
from any obstructions.
2-
Verify
main
electrical supply
is
working without any electrical break in
connections.
3-
Verify the door is properly closed.
DISHWASHER DOES NOT WASH
WELL ?
1-
Verify if the filters are cleaned, if not,
clean them. (see par. 3D4)
2-
Verify if the washing water jets on the
washing arms are not obstructed by
any solid residues.
3-
Verify correct amount and quality of
detergent and rinse aid. (see par.
3B2/3C2)
4-
Verify if the dishes are correctly
loaded on the dishwasher. (see par.
3B6/3C7)
5-
Washing cycle is too short. Use
another cycle (if available) or repeat
the washing cycle.
THE DISHES ARE NOT RINSED
WELL?
1-
Verify if the rinse water jets on the
washing arms are not obstructed by
any solid residues.
2-
Verify solenoid valve filter is free from
any obstructions such as lime or scale.
3-
The inlet water pressure is inferior of 2
bar – 200 kPA. Install an external
pressure
device
to
ensure
and
increase the inlet water pressure
inside the machine.
THE DISHES ARE NOT DRIED WELL ?
1-
Ask the rinse aid supplier to verify the
instruction for the rinse aid dosing.
(see par. 2D)
2-
Verify if the rinse aid container is
empty. If yes, fill it with rinse aid
product. (see par. 2D)
3-
Verify the quality and the quantity of
the rinse aid used and check with the
supplier. (see par. 2D)
4-
Verify the rinsing temperature is
between 80°C (176°F) to 90°C (194°F)
degrees.
CONDENSATION ON GLASSES ?
1-
Verify if the rinse aid container is
empty. If yes, fill it with rinse aid
product. (see par. 2D)
2-
Verify the quality and the quantity of
the rinse aid used and check with the
supplier. (see par. 2D)
3-
Remove the glasses rack immediately
after the end of each cycle.
STAINS ON GLASSES ?
1-
Use only non foaming products for
professional dishwashers.
EXCESSIVE FOAM IN THE TANK ?
1-
Verify washing water temperature is
not less than 50°C (122°F) degrees.
2-
Ask the assistance service to verify the
instruction for the rinse aid dosing.
(see par. 2D)
3-
Ensure the tank has not been cleaned
with unsuitable cleaners. Drain the
tank and rinse throughly before new
wash cycles.
4-
If foaming detergent has been used,
drain and refill the tank with water
until the foam disappears.
SMEARS OR SPOTS ON THE GLASSES ?
1-
Ask the supplier to verify the
instruction for the rinse aid dosing.
EMERGENCY
IN
CASE
OF
FIRE
A
POWDER
EXTINGUISHER MUST BE USED.
IN CASE OF DANGER CUT-OFF THE
ELECTRICAL SUPPLY IMMEDIATLY.
The Manufacturer reserves the right to
modify the data presented in this
publication without notice.
