Jersey Jack Pinball Dialed in!, Руководство по эксплуатации

Страница: 60 / 372

The Dialed In Menu System B-18
Theater Magnet Test
When you enter the Theater Magnet Test , the LCD monitor will display the screen shown in figure
B18. The left square on the screen represents the state of the entrance opto for the Theater (in the
upper center of the playfield). This square turns green when a ball is shot into the Theater
(breaking the opto pair's infrared light beam). The middle square represents the state of Theater
Magnet. This square turns red when the Theater Magnet is activated. The square on the right
turns light tan when the Theater Magnet is cooling down (this typically occurs immediately after a
magnet
activation). A transparent square indicates an inactive opto, no magnet activation, or no cooling
taking place.
To test the Theater Magnet, roll a ball up into the Theater. The switch should register the ball
entering the Theater and the magnet should catch the ball. The magnet should then release the
ball, pause, then activate again, "tossing" the ball through the tunnel behind the Theater, up into
the pop bumpers or around the top of the right orbit, to the upper right flipper.
You can adjust the length of the pause/delay at the top of the screen. To make a change, press the
Enter button, then use the Up/+ and Down/- buttons to specify a new numeric value (positive or
negative). Once you’re finished adjusting the delay, press the
Enter
button once again to apply the
change. To cancel the change, press the Back/Escape button. Try several delay values to find the
one that works best for your game setup.
Note: When the coin door is opened, the game’s safety interlock switch (the upper switch on item
4b, pg C-2 of this manual) disables the 70-volt power running to the playfield. To allow coils to
function in the Theater Magnet Test , you must either close the coin door or pull the safety
interlock switch’s actuator out (it will “click” and lock in place). When you close the coin door, the
interlock switch actuator will be pushed back into its normal (unlocked) position.
To exit the
Theater Magnet Test
at any time, press the
Back/Escape
button.
Figure B18. Theater Magnet Test screen.