Jersey Jack Pinball Dialed in!, Руководство по эксплуатации

Страница: 366 / 372

Game Service & Troubleshooting E-12
8)
Holding onto the tape “handle” with one hand, free the battery from its holder clip with the other.
Ensure that the battery does not touch anything on the surface of the CPU board as you pull it out of
its holder and away from the PCB Chassis.
9)
Pull the tape “handle” off of the old battery and apply it to the top of a new CR2032 battery.
10)
Again, momentarily touch the lockdown bar on the game.
11)
Holding the new battery’s tape “handle”, carefully insert it into the battery holder, in the same
orientation as the old one (battery label/imprint facing outward ). Ensure that the battery snaps into
its holder properly.
12)
Carefully remove the tape “handle” from the top of the new battery, ensuring that you do not
pull the battery out of its holder in the process.
13)
Power the game down.
14)
Replace the Backbox PCBs EMI Shield Enclosure lid and re-install the four HWH Phillips machine
screws.
CAUTION
: Be careful not to pinch any wires in between the lid and the EMI shield enclosure!
15)
Pivot and swing the 27" LCD back into the backbox. Align it with the left and right side latches.
Carefully push one side of the monitor in at a time, lifting the appropriate latch as you do so. Ensure
the monitor is all the way inside the backbox, on BOTH sides, held firmly in place by the two latches.
16)
Re-install the game's backglass. Re-lock the backbox lock and put the key back on the hook,
alongside one of the coin mechanisms, inside the coin door. Close the coin door.
Note:
If your game’s CPU battery discharges below 3V (or if you remove the battery) while the game is
turned off, all BIOS settings will return to factory defaults. As a result, your game will not boot properly the
next time you attempt to power it up. In this case, contact JJP® technical support for assistance in restoring
your CPU BIOS settings and getting your game to successfully boot again.