INSTALLATION MANUAL
ZPS-
K5.3,
K10.3, K20.3 CLAMPING
MODULE WITH SENSOR
MONITORING, MOUNTING FLANGE
877.426.2504
SUBJECT TO TECHNICAL CHANGES.
21
JERGENS INC. · PHONE: 216.486.5540 · FAX: 216.481.6193 /553720 / 553721/
6.
MAINTENANCE
6.1
Introduction
Appropriate maintenance is important for a long service life of the
system and its components under proper functional and operating
conditions, and it also guarantees the required operating safety over the
long term.
6.2
Safety during maintenance
All maintenance steps must be undertaken by qualified personnel
(see chapter 0.1).
Here are the most important points for the performance of
maintenance measures:
Maintenance and repair measures must be undertaken with a
depressurized system. The entire operating, maintenance and
cleaning personnel must also strictly observe the applicable accident
prevention regulations in the country where the machine is installed.
The ZPS is constantly under high spring pressure. Due to the pre-
tensioning of the spring stack, serious, even life-threatening injuries
can result from improper maintenance.
Always wear safety shoes and all other required individual safety gear
as well as clothing that covers the body as completely as possible.
Do not wear any rings, watches, necklaces, bracelets or loose
clothing.
To guarantee flawless functioning, use only original replacement
parts.
Do not use abrasive or corrosive materials for cleaning the ZPS as
they may impair the legibility of the markings
or type plates.
6.3
Daily maintenance
Check the interior of the ZPS for contamination. It can be cleaned with an
ordinary commercial compressed air gun (wear safety goggles) or with a
chip vacuum.
CAUTION:
