INSTALLATION MANUAL
ZPS-
K5.3,
K10.3, K20.3 CLAMPING
MODULE WITH SENSOR
MONITORING, MOUNTING FLANGE
877.426.2504
SUBJECT TO TECHNICAL CHANGES.
15
JERGENS INC. · PHONE: 216.486.5540 · FAX: 216.481.6193 /553720 / 553721/
Remove threaded pin
Insert assembly tool (5),
loosen cylinder screws (2)
evenly
Screw in threaded pins (3) so
you can press down the
clamping system
Uniform and tilt-free
extraction of the clamping
system
Note on installation tool (5)
: Screw a long cylinder screw with a large
washer that covers the central hole for the
pull stud
into the base of the
ZPS. In this way, the ZPS can be held together before removal so that it
can be taken out as a unit. The supply holes for the pressure
medium must be free during removal, as otherwise a vacuum could arise
in the mounting hole.
CAUTION Spring is pre-tensioned in the installed state
.
