Page | 6
Quick Start Procedure Continued
The count, or batch, can be set between 1and 99, press the
F2
button to move from
the ones place to the tens place, press the
F3
button again to increase the tens place
between 0 and 9.
When finished setting the count, save and exit by pressing and holding the
F1
button
until you hear the buzzer* sound twice and the word
HIOS
scrolls across the display.
* If the buzzer has been disabled it will not sound!
The Quick Start Procedure may set a wider range between the Minimum number of rotations and
the Maximum number of rotations than you would want. By using the set up mode functions you
can customize the set up to where you could detect a missing washer or an improper length
fastener.
Navigating the User Interface
The following shows the different displays as seen in the order they appear as you scroll through
the different functions by pressing and releasing the F1 button. The numbers shown in the
display drawings below are the factory default settings and will change to reflect the values you
choose for your application
Instructions on how to set each different function can be found starting on page XX
1.
Press and hold
F1
for 2+ seconds until [P ] appears to enter the setup mode.
Release the
F1
button to see [On ] show on the display.
2.
With [On ] showing, press and release
F1
to see [n05] on the display.
With [n05] showing, press and release
F1
to see [u60 ] on the display.
3.
With [
u
60
] showing, press and release
F1
to see [
n
20] on the display.
With [
n
20]
showing, press and release
F1
to see
[
├
1.0]
on the display.
Navigating the User Interface Continued
